From: http://www.communica.se/multitech/gprs_at.pdf
Values:
[mode]
0: One shot requested
1: Automatic shots requested
2: Stop automatic shots[requested dump]
1: Main Cell:
• If the Cell Identity is available MCC, MNC, LAC, CI, BSIC, BCCH Freq (absolute), RxLev, RxLev Full, RxLev Sub, RxQual, RxQual Full, RxQual Sub,Idle TS
• If the Cell Identity is not available MCC, MNC, LAC, BSIC, BCCH Freq (absolute), RxLev, RxLev Full, RxLev Sub, RxQual, RxQual Full, RxQual Sub,Idle TS
This gives me ERROR:
AT+CCED=0,1 ERROR
What should be interpreted from the text and the error?
CCED isn't a standard AT command from 3GPP TS 27.007 (standard GSM/UMTS/LTE AT commands). It's also not in the proprietary AT command manuals for a couple of well-known mobile platforms.
The first and most obvious conclusion to draw, is that this AT command isn't supported for your device.
The manual you reference is from MultiTech - I am not sure if +CCED is a proprietary AT command of theirs, or if it comes from somewhere else. But it seems that it isn't standard, anyway.
Having looked at the documentation, there is a lot more text than you have pasted above, and it's pretty complicated, as there are a lot of different possible combinations and responses. I think you are along the right lines, the first command to try would be AT+CCED=0,1, and you would expect one single answer, containing the specified data set for the cell on which your device is currently registered.
Do you really need to use this command, or is there an alternative? Which measurements do you need to get? With 3GPP standard AT commands you can get the following:
AT+CREG? gives CellId and LAC
+CSQ gives RSSI in dBm and RXQUAL
You can get information about neighbouring networks using AT+COPS=? but it doesn't give signal quality measurements.
These AT commands are documented in 3GPP TS 27.007.