i wanted to use 4Mb baud rate of stm32f103 usart. how can i check that data received in PC are correct? I used hyper terminal but in its setting there is no 4Mb baud rate and when i run my code i receive wrong characters.but in low baud rates like 115200b data received correctly.
If the transmitter and receiver are not sending at the same speed, the receiver will erroneously read the data. Each byte has a start bit that synchronizes the receiver, and the remaining bits are determined by time.
Typical PC RS-232 serial ports only go up to 115200 bps. It is likely that your PC can't handle the 4 Mbps rate. I would recommend using 115200 or lower speed.
If you are communicating between devices and need higher speed, and just using the PC to debug, you could change the speed for debug purposes and set it faster once your comms are working. Alternatively, you could use a logic analyzer - This could be tedious to do manually, but some may have functions to read serial data.