stm32elfbinobjcopy

Objcopy elf to bin file

I have STM32F404 board and I am trying to flash it. I am following this tutorial.

In the project Makefile

$(PROJ_NAME).elf: $(SRCS)
    $(CC) $(CFLAGS) $^ -o $@ 
    $(OBJCOPY) -O ihex $(PROJ_NAME).elf $(PROJ_NAME).hex
    $(OBJCOPY) -O binary $(PROJ_NAME).elf $(PROJ_NAME).bin

burn: proj
    $(STLINK)/st-flash write $(PROJ_NAME).bin 0x8000000

The bin file is generated using OBJCOPYand then flashed using the Make target burn

My questions :

Question 1: What does OBJCOPY=arm-none-eabi-objcopy in this case. I opened the man but I didn't fully undrestand can anyone explain it simply ?

Question 2: Flashing the bin file gives the expected result (Leds blinking) However the leds are not blinking by flashing the elf file $(STLINK)/st-flash write $(PROJ_NAME).elf 0x8000000 so why ?

Solution

  • Question 1: What does OBJCOPY=arm-none-eabi-objcopy in this case. I opened the man but I didn't fully undrestand can anyone explain it simply ?

    It assigns value arm-none-eabi-objcopy to make variable OBJCOPY.

    When make executes this command:

    $(OBJCOPY) -O binary $(PROJ_NAME).elf $(PROJ_NAME).bin

    the actual command that runs is

    arm-none-eabi-objcopy -O binary tim_time_base.elf tim_time_base.bin

    Question 2: Flashing the bin file gives the expected result (Leds blinking) However the leds are not blinking by flashing the elf file $(STLINK)/st-flash write $(PROJ_NAME).elf 0x8000000 so why?

    The tim_time_base.elf is an ELF file -- it has metadata associated with it. Run arm-none-eabi-readelf -h tim_time_base.elf to see what some of this metadata are.

    But when you processor jumps to location 0x8000000 after reset, it is expecting to find executable instructions, not metadata. When it finds "garbage" it doesn't understand, it probably just halts. It certainly doesn't find instructions to blink the lights.