Car failed to change the route error in anyLogic
I am Simulating the road traffic model in anyLogic. I am making a cross road network of four roads using one intersection and two car source. I have used select Output5 twice as seen in screenshot below.
Here road on East side is named as RoadE, road on West side is named as roadW, road on North side is named as roadN and road on South side is named as roadS.
Logic:-
Every time i am trying to run the model, it is throwing same exception as :
Why this agent is not able to choose right lane?
Solution
Make sure that the road segment (where the car comes from) is long enough. If it is too short, some cars might not have enough space and time to switch into the required lane.
Just make your bottom road a little longer and it will work.
- queue animation with custom population
- stop event triggered by rate in some states of my simulation
- Nodes with access restriction causing error of pedestrian unable to reach target
- Is there a function in AnyLogic to display an alert message during model run?
- How to ensure the downtime is functioning in ResourcePool Element in Anylogic
- Building a time stack chart in AnyLogic
- Statechart transition rate: Number is not matching with actual rate
- Editing Main.java
- Resetting an objects counter in anylogic
- How to set a custom texture for a wall (Ped Library)
- How do I make AnyLogic recognize the Lombok plugin?
- How to set up an cyclic event on anylogic
- How can I define the GIS locations of agents in anylogic?
- Combine two resources and then send to a node in Anylogic
- How can i alter between database sheets in anylogic?
- How to select multiple GIS regions in AnyLogic source block?
- Dynamic parameters in Anylogic
- How can I optimise my cost objective function while limiting total time taken for the whole process?
- How to access ResourcePool of higher level agent?
- Separation of agents from their population
- Rate from Database in Anylogic
- Release of agents at the same time
- Schedule of the opening and the closing of a valve in Anylogic
- How to get access to agents parameters from inside the dynamic event in anylogic?
- How to send a message between agents (to a specific state chart transition) while the agents are in the same class in Anylogic
- How to deal with Anylogic Error in Split Block
- How to get remaining time of delay of "Delay" block in Anylogic
- How to count number of business days between two dates in AnyLogic?
- How to get X coordinate of crane bridge to put it in a variable in Anylogic
- How to make a transporter that releases an item and always take it back right after?