I went to step 7 https://coral.ai/docs/dev-board/get-started/#run-demo After I hit the command edgetpu_demo --stream, the console has the message below and then the system rebooted.
INFO:edgetpuvision.streaming.server:Listening on ports tcp: 4665, web: 4664, annexb: 4666 INFO:edgetpuvision.streaming.server:New web connection from 192.168.1.6:62609 INFO:edgetpuvision.streaming.server:Number of active clients: 1 INFO:edgetpuvision.streaming.server:[192.168.1.6:62609] Rx thread finished INFO:edgetpuvision.streaming.server:[192.168.1.6:62609] Tx thread finished INFO:edgetpuvision.streaming.server:New web connection from 192.168.1.6:62610 INFO:edgetpuvision.streaming.server:Number of active clients: 2 INFO:edgetpuvision.streaming.server:[192.168.1.6:62609] Stopping... INFO:edgetpuvision.streaming.server:[192.168.1.6:62609] Stopped. INFO:edgetpuvision.streaming.server:Number of active clients: 1 INFO:edgetpuvision.streaming.server:New web connection from 192.168.1.6:62611 INFO:edgetpuvision.streaming.server:Number of active clients: 2 INFO:edgetpuvision.streaming.server:[192.168.1.6:62610] Rx thread finished INFO:edgetpuvision.streaming.server:New web connection from 192.168.1.6:62612 INFO:edgetpuvision.streaming.server:Number of active clients: 3 INFO:edgetpuvision.streaming.server:[192.168.1.6:62611] Rx thread finished
Need I update some modules such as GStreamer, etc.?
Board reboot can occur if board is not getting enough power. Please make sure to boot the board with at least 2.1 - 3 amp of power adaptor.