How to Debug in STMCubeIDE?
I am new to STM32. I have recently installed STM32CUBEIDE. I have written basic code . connected ST-Link v2 (STM8 & STM32) to my laptop and pressed F11 (to debug). I get the following error
Error in initializing ST-LINK device.
Reason: ST-LINK firmware upgrade required. Please upgrade the ST-LINK firmware using the upgrade tool.
I get the following pop-ups.
After clicking yes.
ST link upgrade shows error as shown below
Now the version of st link upgrade is 3.37.
I manually downloaded St link upgrader of version V2.J36.S7
Here after manually upgrading the firmware of ST link I get the same error with the same reason. What I could gather is that latest version of ST link upgrader does not work with my ST link dongle but to debug and upload code I need to upgrade it via STMCubeIDE but that does not happen.
If I missed something please guide me. Thanks for helping me.
I hate the same problem a while a go. In my chase the debugger it self (st/linkv2) was broken and I tried to upload it with a other dongle and it worked fine. So it could be just be a broken dongle.
- Analyse data from LoRa data transfer STM32WLE5JC
- How to read a whole uint_8 variable?
- Is that possible the generate without comments main.c in stm32Cubeide
- stm32cubeide reports firmware package is missing
- STM32CubeIDE debugger no longer works in macOS 15.0 Sequoia
- How to update the section in ELF file, using a binary file
- Disable source formatting in stm32cube for a small part in a source file
- Defining constants for STM32 GPIO
- Why is my STM32F407 not being recognized by the computer (Windows 10)?
- STM32F103RET6, ST-LINK V2, DEV_TARGET_CMD_ERR, SWD does not work properly
- How can i start the GDB server in stm32cubeide?
- STM32G031J6M6 programmed once
- STM32 - Is reading/writing singular bits inside registers with these custom structs ok?
- Unable to read external flash with FATFS. STM32
- STM32CubeIDE: How to disable auto re-generation the code when .ioc saved
- The interface firmware FAILED to reset/halt the target MCU
- STM32CubeIDE Run Configurations: How to disable 'Set breakpoint at: main' if grayed out
- STM32F103 Switch I2C pins
- STM32CubeIDE Headless build in gitlab's CI/CD problem
- NUCLEO-H723ZG Printf (SWV) not working on STM32CubeIDE
- STM32 wake up stop mode for usart
- STM32 Cube IDE - after initial successfull launch and use now remains idle during splash screen launch stage (Linux)
- Converting u8_t to JSON and manipulate data, in C
- Creating an Array and filling it with ADC values - STM32L476G
- write to SDRAM in STM32f7xxx
- Extremely Simple Program Won't Compile
- Came up with an "Unable to stat debugging" error when Debug program for STM32 NUCLEOF103RB
- STM32F4 Uart data forwarding uses DMA and packet loss occurs
- (STM32H7) Updating makefile from TouchGFX in order to add header files that the compiler does not see
- MQTT on STM32CubeIDE (hardware STM32F756ZGT6 nucleo-144)