I'm currently working on a project where I want to vary the PWM to a motor given an input from a potentiometer. However, I cant seem to use the serial monitor and an analogWrite statement in the same program.
When I run this code I get this output from the serial monitor:
void setup()
{
Serial.begin(115200);
Serial.println();
Serial.println();
Serial.print("WORKING");
//analogWrite(1, 255);
}
void loop()
{
}
12:09:48.314 ->
12:09:48.314 -> WORKING
However, when I run this code (the only difference is that the analogWrite() line is no longer commented out), the serial monitor outputs garbage.
void setup()
{
Serial.begin(115200);
Serial.println();
Serial.println();
Serial.print("WORKING");
analogWrite(1, 255);
}
void loop()
{
}
{l$ܞ⸮⸮$⸮| ⸮⸮l⸮ #|⸮⸮⸮⸮{⸮#⸮ "⸮⸮on⸮lon⸮⸮⸮ #p⸮⸮bl`{lp⸮o⸮ ⸮l ⸮⸮ bo⸮|⸮ ⸮⸮ #⸮⸮nN⸮$⸮⸮$`⸮on⸮{lor⸮⸮⸮⸮ {r⸮ p⸮o⸮ s⸮ܜ⸮⸮⸮ # o⸮| ⸮ B⸮⸮on⸮ ⸮l ⸮No⸮{lor⸮⸮⸮N rd`{⸮⸮N {d`⸮ ⸮⸮⸮⸮⸮$`⸮⸮N⸮l
⸮
Does anyone know why this is happening and how to fix it?
Not sure if it helps but im using an ESP8266 NodeMCU purchased from this amazing link: https://www.amazon.com/gp/product/B081CSJV2V/ref=ppx_yo_dt_b_asin_title_o07_s00?ie=UTF8&th=1
analogWrite(1, 255) is writting to GPIO1. If you look at the pin-out for the ESP8266 NodeMCU, GPIO1 is the TXD line for serial port 0 (it's labeled TXD0). I don't have a NodeMCU schematic handy, but port 0 is typically used for the serial monitor and wired to the USB-UART converter for that purpose. So by writing to GPIO1, you are interfering with the monitor output.
Try doing an analogWrite to a different GPIO, for example, GPIO5.